Pontiac 2005 GTO Uživatelský manuál stáhnout pdf (Strana 206)

Get the vehicle warmed up by driving about 15 miles

(24 km) when outside temperatures are above 50°F

(10°C). If it is colder than 50°F (10°C), drive the vehicle

in DRIVE (D) until the engine temperature gage

moves and then remains steady for 10 minutes.

A cold ﬂuid check can be made after the vehicle has

been sitting for eight hours or more with the engine off,

but this is used only as a reference. Let the engine

run at idle for ﬁve minutes if outside temperatures are

50°F (10°C) or more. If it is colder than 50°F (10°C), you

may have to idle the engine longer. Should the ﬂuid

level be low during this cold check, you must check the

ﬂuid hot before adding ﬂuid. Checking the ﬂuid hot

will give you a more accurate reading of the ﬂuid level.

Checking the Fluid Level

Prepare your vehicle as follows:

• Park your vehicle on a level place. Keep the

engine running.

• With the parking brake applied, place the shift lever

in PARK (P).

• With your foot on the brake pedal, move the shift

lever through each gear range, pausing for about

three seconds in each range. Then, position the shift

lever in PARK (P).

• Let the engine run at idle for three minutes or more.

Then, without shutting off the engine, follow

these steps:

The automatic transmission dipstick is located at the

rear of the engine compartment, on the passenger’s side

of the vehicle. See Engine Compartment Overview on

page 5-12 for more information on location.

1. Unclip the handle and remove the dipstick; wipe it

clean with a clean rag or paper towel and re-insert

it fully. Remove it again and read the ﬂuid level.

2. Check both sides of the dipstick, and read the lower

level. The ﬂuid level must be in the COLD area for

a cold check or in the cross-hatched HOT area

for a hot check.

3. If the ﬂuid level is in the acceptable range, push the

dipstick back in all the way.

Remember to always replace the dipstick and lock

the handle down.

How to Add Fluid

Refer to the Maintenance Schedule to determine what

kind of transmission ﬂuid to use. See Recommended

Fluids and Lubricants on page 6-12.

Add ﬂuid only after checking the transmission ﬂuid while

it is hot. A cold check is used only as a reference. If

the ﬂuid level is low, add only enough of the proper ﬂuid

to bring the level up to the HOT area for a hot check.

5-20

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 317 318

Komentáře k této Příručce

Žádné komentáře

Pontiac 2005 GTO Uživatelský manuál Strana 206

Komentáře k této Příručce

Související produkty a manuály pro Auta Pontiac 2005 GTO